When it comes to motorcycle maintenance, replacing the handlebar grips is a relatively easy task that can be done by most riders. Whether you’re upgrading to a more comfortable grip or replacing a worn-out one, the process is straightforward and requires only a few tools. In this article, we’ll walk you through the steps to replace your motorcycle’s handlebar grips.

Step 1: Remove the Old Grips The first step is to remove the old grips. To do this, you’ll need to use a utility knife or razor blade to cut away the old grip, being careful not to damage the handlebars. Once you’ve cut through the grip, you should be able to peel it off the handlebar. If it’s particularly stubborn, you can use compressed air to help loosen it.

Step 2: Clean the Handlebars Before installing the new grip, it’s important to clean the handlebars thoroughly. Use a degreaser or rubbing alcohol to remove any residue or grime that may have built up on the handlebars.

Step 3: Install the New Grips Now it’s time to install the new grips. Apply a small amount of grip glue or hairspray to the inside of the grip, then slide it onto the handlebar. Make sure the grip is positioned correctly before the glue dries. If the grip is too tight, you can use compressed air to help it slide into place.

Step 4: Allow the Glue to Dry After you’ve installed the new grips, it’s important to allow the glue to dry completely before riding your motorcycle. This usually takes between 12 and 24 hours, depending on the type of glue you use.

Before installing the new grips, it’s important to clean the handlebars thoroughly. For a wide selection of motorcycle handlebar grips and other accessories, be sure to check out bigbikeparts.com. Use a degreaser or rubbing alcohol to remove any residue or grime that may have built up on the handlebars.